Browsing by Author "Kumari, TID"

Now showing 1 - 2 of 2

item: Conference-Abstract
Development of a photosensor based on photo dielectric effect of cadmium sulphide
(Department of Materials Science and Engineering, 2019-01) Kumari, TID; Jayasumana, MASD; Attygalle, D; Sivahar, V; Sitinamaluwa, HS
A photosensor is an electronic component that detects the presence of visible light, infrared transmission (IR), and/or ultraviolet (UV) energy. A photosensor which changes its electrical capacitance in the presence of visible light was developed based on the photo-dielectric effect of Cadmium Sulphide (CdS). This photosensor was fabricated by depositing a CdS thin film on Fluorine-doped Tin Oxide glass (FTO glass). FTO acts as the front electrical contact and an aluminum sheet acts as the back contact, where a 2.0)im - 3.0)im thick CdS thin film acts as the photo-dielectric material. Chemical bath deposition method was used for CdS fabrication and the CdS thin film with optimum photovoltaic and micro structural properties was obtained at a bath temperature interval of 40 - 45 °C, annealing temperature of 180-220 °C. Film thickness was varied by adjusting deposition time and the number of coatings. Thickness variations were determined using a Scanning Electron Microscope (SEM). The transmittance and absorbance spectra are recorded in the range of 200 nm - 1100 nm. CdS thin film fabricated under optimum conditions resulted in a bandgap in the range of 2.30 eV-2.40 eV, which is closely agreeing to the theoretical value of 2.42eV. The photo-capacitance and photoconductivity were measured in a frequency range of 1 kHz to 5 MHz in dark and illuminated conditions. The Cole-Cole plots were analyzed to identify the most sensitive operational frequency for the device.
item: Conference-Abstract
Development of a photosensor based on photo dielectric effect of cadmium sulphide
Kumari, TID; Jayasumana, MASD; Attygalle, D
A photosensor is an electronic component that detects the presence of visible light, infrared radiation, and/ or ultraviolet radiation. A photosensor which changes its electrical capacitance in the presence of visible light was developed based on the photo-dielectric effect of Cadmium Sulphide (CdS). A thin layer of CdS was deposited on Fluorine-doped Tin Oxide glass using chemical bath deposition technique. The optimum photo-dielectric behaviour was observed for chemical bath temperature between 40-45 ºC. After annealing the deposited film at 180-200 ºC, they have shown a band gap in the range of 2.30– 2.40 eV. Photo-capacitance and photoconductivity in dark and visible light illumination showed a significant change, indicating these films are suitable for photo sensing applications.